Trending Now
GAOA Merchandise: Order yours today!
Flush Riveting Tips
The GlaStar is not typically built with flush rivets, but some builders are using them anyway. This does not improve aerodynamics, but helps if...
Sportsman Trim Saga & Safety-Trim
Until recently, I had been having problems with the electric pitch trim system in my Sportsman. It’s the standard electric setup using the Ray...
Technique for Cutting Stainless Engine Mount Backing Plates
This tip was submitted by Richard May, Glasair III.
I found a method that makes the job of cutting, shaping and drilling the engine mount backing...
First Flight of Bill Kerschbaum’s Glasair I-RG
Bill reports: "Successful first three flights in my Glasair I-RG last week. Working on some squawks, and hope to continue flying later this week....
Vapor Lock Causes Trouble Over Water
This cautionary tale was submitted by Al Lange.
After 4 years and 6,000 hours in construction, two long-time pilots were finally on the way to...
