GAOA Merchandise: Order yours today!

GLASTAR & SPORTSMAN

GlaStar seat pan inspection cutouts
Mods

Seat Pan Inspection Access Cutouts

This modification was submitted by Jim Rose. These are my GlaStar seat pans with the inspection plates added. I found this necessary as I wanted to...
How to & Builder Tips

Keeping Oil Temperatures Low

Sorting out the oil temperature issues and CHT temperature spread was a bit of a challenge. Extended climbs during Sydney summers had to be...

Proportional Servo Elevator Trim Control For the Glastar

Mods
Glastar left wing in jig

GlaStar Wing Trailing Edges

How to & Builder Tips
GlaStar prototype

GlaStar Development Report

GlaStar & Sportsman
GlaStar - drilling the flap skin doublers

GlaStar Aileron and Flap Installation Tips

How to & Builder Tips

GLASAIR

Flying

Testing the Airspeed Indicator

While flying off your test time, why not check your airspeed gauge? A simple, somewhat accurate way, if you have access to GPS, is...
Aircraft Spruce rudder pedals in GlaStar
Mods

Cast Rudder Pedals

This tip was sent by Chris Lowery. I never did like the cheap riveted metal plates SHAI had us make as rudder pedals, and nor...
Glasair III engine installation

Glasair III Engine Alignment, Cowling, and Spinner Installation

How-to and Builder Tips
eyedropper for resin promoter

Properly Promoting Resin

How to & Builder Tips
Figure 1. View looking down right side - Internal passages FVFV top.

Testing Procedure for Fuel Vent Float Valve Check Valves

Maintenance
Glasair fuel tank flapper valve

Splitting the Glasair Main Fuel Tanks

How-to and Builder Tips

PEOPLE & PLACES

Join GAOA

Sign up for full access.

 Get Started! 

Already a member? Log in.

- Advertisement -

ARTICLES YOU MAY HAVE MISSED

RESOURCES

© Copyright Glasair Aircraft Owners Association. All rights reserved.